Efficiency leap Precision and stability
We work with CNC bending machine, there is a high probability that some errors will occur, then we have to pay attention, once the problem has to be checked immediately. The first step in the check is the bending machine is now using the mold whether there is wear or damage to the problem exists, if this is the cause of the error, then replace a mold is good.
Efficiency leap Precision and stability
But in the process of checking, if no damage is found, the second step to check the balance of the slider and table, if the site can not meet the requirements of use, we must adjust in accordance with the relevant standard requirements, so that this parallelism can be maintained within the standard range.
If the angle of the workpiece still exists a certain error, it may not be because of the mold, or parallelism of the problem, it may be the equipment's hydraulic system, the balance of the mechanism does not ensure that the pressure oil uniformly into the left and right cylinders caused by that need to be adjusted.
At this time, the bending machine to adjust the working mode to the "point adjustment" state, remove the equipment on the mold, or some other attachments, so that the slider stays in the mechanical block, and then the pressure gauge to adjust the correct practice is to bend the machine in the percentage of the meter head compression 3-4 mm, step on the foot pedal to let the system pressurization, in the bending machine! When the system is pressurized or when the system is discharged, check the offset of the hour hand of the percentage gauge, and stop the operation if it reaches the specified value. Of course, in addition to the above ways, to emphasize the need to maintain a good bending machine, so that it can play the maximum advantage of use!
